Whats with the star on it's nose?? some of it is cool.. I dunno if I like the headlights or not.. but someone did some nice custom work on it that is for shure..
don't know if I like it.....hmmmmm nope...
nice clean car though....a great mind once said
"there's a car out there for everyone"...this just isn't mine
Like VetteTech81 said. Someone did some good custom work. I think it looks pretty good. Good paint, decent body lines. The headlights ought to be in the grill opening though. Overall pretty clean, bu that damn wing has got to go
I need help getting my 68 wiper system to work, I'm installing the new lectric limited dash harness into the car. After a 7 yr total rebuild
I have gone with the LS1-TS6 conversion, and have got the headlight doors and wiper doors converted to electric, no more vacuum to rely on
I followed wiper...
I'm installing the ps control valve onto the drag link (not installed on the car yet). The valve is very hard to thread onto the rod. I put it in a vise and used a pointed bar to rotate it but I can only get it to within about 1/4 inch of all the way on. The bolt went in okay but I'm not sure if...
Hey guys, what's the easiest way to check my LS3 fuel system for leaks (before I put the body back on) - setting up the system with in-tank pump (Tank's Inc GPA pump), the corvette LS filter/regulator, Holley Fuel rails with pressure gauge on the inlet to the rail. Without attaching any...
My 1978 manual states 20-25 in-lbs for new pinion bearings, but other sources state 14-19 and 15-17. Which is correct? It is intended to be a moderate performance street daily driver. Also, my current out of the car differential 10 bolt clockwise (from the front) is 16-19 in-lbs, but...
Corvette Forum : DigitalCorvettes.com Corvette Forums
A forum community dedicated to Corvette C Series owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
:laughing: :laughing: :laughing:
matchframe · updated 
77blue · updated 
